纤维曲线铺放制备变刚度复合材料层合板的研究进展  

RESEARCH AND DEVELOPMENT ON VARIABLE-STIFFNESS COMPOSITE LAMINATES MANUFACTURED BY VARIABLE ANGLE TOW PLACEMENT

作　　者：秦永利[1] 祝颖丹[1] 范欣愉[1] 颜春[1] 李晓拓[1] 张笑晴[1] 

机构地区：[1]中国科学院宁波材料技术与工程研究所,宁波315201

出　　处：《玻璃钢／复合材料》2012年第1期61-66,共6页Fiber Reinforced Plastics/Composites

基　　金：国家973项目(2010CB631100);宁波市攻关项目(2011B1015);中科院方向项目(KGCX2-EW-210)

摘　　要：纤维曲线铺放技术可以同时对刚度和强度进行剪裁优化设计,由此制得的变刚度复合材料层合板与传统的复合材料层合板相比,其重量和成本可以减少10%～30%,同时结构性能得到显著提高。本文先介绍了纤维曲线铺放技术及变刚度复合材料的概念,对比分析了纤维曲线铺放的两种方法,然后讨论了变刚度复合材料层合板设计制造的主要问题,重点论述了纤维曲线铺放变刚度层合板的应用研究,最后对纤维曲线铺放技术的应用前景进行了展望。The application of variable angle tow(VAT) placement technology allows the optimal tailoring of both stiffness and strength.Compared with traditional laminated fiber composites,it will reduce weight and production cost by at least 10%(possibly up to 30%) and improve the structural efficiency significantly.A review of recent work on variable-stiffness composites prepared by the VAT technology is presented here.This review introduces some basic definitions of the VAT technology and variable-stiffness composites.Comparisons between the two placement methods are also discussed.Then,the key issues existing in the design,fabrication and application of variable-stiffness composite laminates are highlighted with a selection of representative literature.

关 键 词：纤维曲线铺放 变刚度复合材料 屈曲 应力集中 

分 类 号：TB3[一般工业技术—材料科学与工程]