固化工艺对环氧胶粘涂层硬度的影响  

Effect of Filler and Curing Procedure on Hardness of Epoxy Adhesive Coating

作　　者：魏晓红[1] 郑小玲[1] 余海洲[1] 张晶晶[1] 

机构地区：[1]三峡大学机械与材料学院,湖北宜昌443002

出　　处：《三峡大学学报（自然科学版）》2004年第3期261-262,269,共3页Journal of China Three Gorges University：Natural Sciences

基　　金：湖北省教育厅科研计划重大项目(2003Z001)

摘　　要：研究了锌和钛粉等填料对AR-5环氧树脂胶粘涂层硬度的影响,结果表明在所采取的实验条件下,加入AR-5耐磨胶中加入钛粉5.7％、锌粉46.2％左右(均为占胶重百分比)的填料时,耐磨胶粘涂层有较高的硬度,固化工艺参数对环氧胶粘涂层的硬度有显著的影响.The influence of Zn and Ti filler addition on the hardness of epoxy coating is investigated. It is found that the higher hardness is obtained under the condition of adding Zn and Ti as filler when the addition is 5. 7% and 46. 2% (wt. percentage of adhesive) respectively. It is also pointed out that the hardness of the adhesive coating layer is remarkably affected by curing parameters.

关 键 词：金属基体 环氧胶粘涂层 填料 硬度 固化工艺 

分 类 号：TG174.44[金属学及工艺—金属表面处理]