用于电火花加工的两级式电流型变换器研究  

Study on Two-Stages Current Mode Pulse Power for Electric Discharge Machining(EDM)

作　　者：穆新华[1] 吴文江[1] 

机构地区：[1]南京航空航天大学航空电源航空科技重点实验室,南京210016

出　　处：《南京航空航天大学学报》2004年第4期492-495,共4页Journal of Nanjing University of Aeronautics & Astronautics

摘　　要：脉冲电源是电火花加工系统中重要的组成部分之一 ,其性能直接影响电加工的工艺指标。与一般电源比较而言 ,它是按一定规律周期性地向负载提供所需的电功率 ,工作过程中存在着很强的扰动性。本文分析了无阻电流型电火花脉冲电源变换器的工作原理 ,提出了一种新型两级式结构的无阻电流型电火花脉冲电源变换器的电路拓扑和控制方案 ,给出了脉冲发生电路和输出过压保护电路的设计方法。制作了输出电流为 2 0 A的原理样机 ,通过实验波形分析 ,验证了电路拓扑和控制方法的正确性 。Pulse power supply is essential for the electric discharge machining, its performance will directly effect the technique index of machining. Compared with normal power supply systems, the electrical discharge machining (EDM) should properly operate under high disturbance occasions and deliver a special periodical power to the load. To resolve the difficulties of EDM pulse power supply currently used, this paper analyzes the operating principles of the two-stages current mode pulse power for EDM. A new circuit topology and control scheme has been introduced; Meanwhile, the design approach of the pulse generating circuit and the over-voltage protection circuit is presented. Finally, the sample one of which the output current is 20 A is completed and tested. Analysis and experiment show that the two-stages current mode converter has a distinct predominance in EDM.

关 键 词：电火花加工 电流型变换器 脉冲电源 工作原理 

分 类 号：TG661[金属学及工艺—金属切削加工及机床] TN624[电子电信—电路与系统]