检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]浙江大学化工系高分子工程研究所化学工程联合国家重点实验室聚合反应工程实验室,浙江杭州310027
出 处:《合成橡胶工业》2004年第4期213-216,共4页China Synthetic Rubber Industry
摘 要:采用无皂乳液聚合法制备了具有单分散性的亚微米级聚苯乙烯微球 ,考察了聚合体系pH值、单体及引发剂用量对聚合转化率、微球粒径及其分布的影响。结果表明 ,采用NaOH和NaHCO3 复合溶液调节聚合体系pH值是控制聚合动力学、微球粒径及单分散性的有效手段 ,当其质量比为 1∶1时效果较好。随碱性复合溶液加入量的增加 ,最终转化率下降 ,微球粒径则由于复合溶液同时起到电解质的作用而存在极大值。随过硫酸钾 (KPS)质量分数的增加 ,反应前期聚合转化率增大 ,但其用量过大 ,会导致体系pH值偏低 ,KPS过早消耗完毕 ,故反应后期最终转化率偏低 ;其用量过低 ,会影响粒径的单分散性。当KPS质量分数为单体的 2 %~ 3%时 ,聚合体系稳定性增加并改善了微球的单分散性 ,粒径趋小。单体用量的变化对聚合速率影响不大 ,随单体质量分数的提高 ,微球最终粒径增大 ,当单体质量分数过高 ,会影响微球的单分散性乃至体系失稳 ,一般以不超过 10The monodisperse micron-size polystyrene particles were prepared by emulsifier-free emulsion polymerization. The effects of pH value,styrene and potassium persulfate (KPS) content on conversion, particle size and its distribution were mainly investigated. The results showed that it was useful method for addition of both NaOH and NaHCO 3 mixed solvent to control polymerization kinetics, size and its monodispersity of obtained particles, which adjusted pH value change during polymerization process. It was better based on its monodispersity when the mass ratio of NaOH to NaHCO 3 was 1∶1. With increasing the basic mixture as both pH alleviant and electrolyte, final conversion decreased and maximum of particle size existed. Conversion increased with increasing KPS content at the early stage of polymerization process. However, the final conversion was lower when excessive KPS was added because the decomposition of persulfate was accelerated and initiator consume rapidly at lower pH value. Uniform and stable particles were obtained via advisable initiator content between 2% and 3% based on monomer. Moreover, the influence of limited change of monomer concentration on polymerization rate could be neglected. Particle size enlarged with higher solid content. However, unstability and broad distribution occured when monomer concentration tends to be higher over 10%.
关 键 词:无皂乳液聚合 动力学 聚苯乙烯微球 单分散性 亚微米级
分 类 号:TQ316.3[化学工程—高聚物工业]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.249