检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]上海大学材料科学与工程学院,上海200072
出 处:《钢铁》2004年第8期108-111,共4页Iron and Steel
基 金:国家自然科学基金资助项目(50171038)国际钒技术委员会博士基金的资助
摘 要:研究了0.11C-0.6Si-1.5Mn冷轧TRIP钢两相区退火温度对组织和力学性能的影响,结果表明,试验钢经780℃退火5 min和400℃等温5min处理后可以获得10%的残余奥氏体,较低或较高的退火温度都将使残余奥氏体量略微下降。当试验钢处理后的铁素体量为70%时,可以获得好的相变诱发塑性和好的强韧性配合,其强塑积可达21000 MPa·%。试验钢的应变硬化指数n值与铁素体量有好的相关性,随铁素体量的下降而下降,残余奥氏体量对其影响不大。<abstract>e influence of intercritical annealing temperature on microstructure and mechanical properties in 0. 11C-0. 6Si-l. 5Mn cold rolling TRIP (transformation induced plasticity) steel sheets was investigated. The maximal volume fraction of retained austenite, which is 10 %, is obtained by heat-treating in 780℃×5 min+400℃×5 min. The best product of strength and ductility, which is 21000 MPa·% , is attained while the steel containing 70 % ferrite. The strain-hardening coefficient, n, depends on ferrite volume fraction. The larger amount of ferrite results in higher n value.
分 类 号:TG156.2[金属学及工艺—热处理]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222