电解工艺对NiFe_2O_4基金属陶瓷阳极耐腐蚀性能的影响  

Effect of Operating Parameters on CorrosionBehavior of NiFe_2O_4 Cermet Inert Anodes

作　　者：秦庆伟[1] 赖延清[1] 孙小刚[1] 李新征[1] 李劼[1] 刘业翔[1] 

机构地区：[1]中南大学冶金科学与工程学院,湖南长沙410083

出　　处：《中南大学学报（自然科学版）》2004年第6期891-895,共5页Journal of Central South University:Science and Technology

基　　金：国家自然科学基金资助项目(50204014);国家重点基础研究发展规划项目(G1999064903);国家高技术研究发展计划项目(2001AA335013)

摘　　要：研究了5%Ni NiFe2O4金属陶瓷惰性阳极在冰晶石 氧化铝熔体中的腐蚀行为及电解参数对腐蚀率的影响。研究结果表明:当Al2O3质量分数大于5%或接近饱和时,电极腐蚀率较低;当Al2O3质量分数小于2%时,电极腐蚀加快;当在冰晶石熔体中不加Al2O3时,会发生灾变腐蚀;当分子比为2.2～2.4,电解温度为960℃时,腐蚀率较低;溶解的铝和高电流密度对惰性阳极的正常工作不利,电流密度适当时有利于降低阳极的腐蚀率;导致惰性阳极腐蚀的主要原因有铝热还原,碳化铝的溶解及电沉积、陶瓷基体的氟化反应。The corrosion behavior of 5%Ni-NiFe_2O_4 inert anodes in cryolite-alumina melts, and the corrosion rates as a function of some operating parameters were investigated. The results show that the corrosion rates increase rather slowly with Al_2O_3 concentration at saturated or (above) 5%; followed by a sharp increase at low concentrations(<2%). Depletion of alumina may lead to catastrophic corrosion. The anodes perform well in the cryolitic ratio range from 2.2 to 2.4 at about 960 ℃. Dissolved aluminium metal and high current density have a detrimental effect on anode performance. Proper current density is of benefit to decrease corrosion rate. The principal corrosion mechanism appears to be the aluminothermic reduction with dissolved aluminium metal, fluoridation of anode matrix and subsequent dissolution in the bath.

关 键 词：铝电解 隋性阳极 金属陶瓷 腐蚀 NIFE2O4 

分 类 号：TF821[冶金工程—有色金属冶金]