凝汽器空冷区铜管汽侧氨腐蚀研究  

AMMONIA CORROSION OF COPPER TUBES IN AIR REMOVAL SECTION IN CONDENSER FOR POWER PLANT

作　　者：朱志平[1] 杨道武[1] 周琼花[1] 马迪东[1] 

机构地区：[1]长沙理工大学,长沙410077

出　　处：《腐蚀科学与防护技术》2005年第2期101-103,共3页Corrosion Science and Protection Technology

基　　金：湖南省教育厅科研资助项目 (0 2C0 68) ;湖南省自然科学基金资助项目 (0 1JJY3 0 2 7)

摘　　要：在 16种浓度的氨溶液 (从 5 0mg/L～ 2 0 0 0 0mg/L不等 )、3种温度 (2 5℃、35℃、4 5℃ )、3种溶解氧的条件下(开口、密闭不除氧、密闭除氧 ) ,对铜管腐蚀过程及影响氨腐蚀过程的因素及规律进行了研究 .结果表明 :氨腐蚀的主要因素为溶氧量、氨浓度、温度 ;尤其以溶氧量影响最大 ,使氨腐蚀的速度随着氧浓度的增加而加快 .最后提出了几种防止氨腐蚀的措施 .To simulate ammonia corrosion process of copper tubes in the air removal section of condenser in power plant,immersion tests of copper tube samples are conducted in ammonia solutions with ammonia 50～20000 mg/L,at temperatures 25℃、35℃ and 45℃ respectively.The tests conditions include:in open atmosphere,in a closed vessel and in deaerated solutions respectively.It is found that ammonia corrosion was mainly affected by the above three factors,especially the concentration of dissolved oxygen,which can influence the ammonia corrosion process greatly.The paper also introduced several preventive measures,which was valuable for engineering practice.

关 键 词：氨腐蚀 凝汽器 除氧 铜管 空冷 溶解氧 氧浓度 冷区 腐蚀过程 开口 

分 类 号：TQ153[化学工程—电化学工业] TK264[动力工程及工程热物理—动力机械及工程]