轨迹成形法加工非球面光学零件新技术的研究——轨迹成形法加工新原理提出的依据  

Research on the New Principle of Machining Aspheric Optical Parts by Locus Shaping Method ——The Basis to Present the Locus Shaping Method

作　　者：王院生[1] 王鹤岩[1] 高路[2] 蔡立[1] 朴承镐[1] 

机构地区：[1]长春理工大学,长春130022 [2]北京理工大学信息科学技术学院,100081

出　　处：《长春理工大学学报（自然科学版）》2005年第1期36-40,共5页Journal of Changchun University of Science and Technology(Natural Science Edition)

基　　金：国家自然科学基金资助项目(59875008)

摘　　要：本文论述了光学非球面零件加工难的原因;分析了解决非球面零件加工难的关键;并指出了数控加工工艺系统对非球面加工造成误差的影响因素,以此得出探索和研究更为有效的加工非球面技术的必要性。In this paper, the causes of difficulty in machined aspheric optical parts is described.it analyzes the key points to solve this problem, and points out that the technology system of numerical control method causes the aspheric machining errors by a lot of factors. Based on this, a conclusion is drawn that it is very necessary to explore a superior aspheric machining method.

关 键 词：光学非球面 加工误差 数控加工 轨迹成形法 

分 类 号：TH706[机械工程—仪器科学与技术]