电极圆锥内螺纹的非接触测量  

Non-contact Measurement on Internal Taper Thread of Electrode

作　　者：刘庆民[1] 王龙山[1] 陈向伟[1] 丁宁[1] 

机构地区：[1]吉林大学机械科学与工程学院

出　　处：《农业机械学报》2005年第6期98-101,共4页Transactions of the Chinese Society for Agricultural Machinery

基　　金：吉林省科技发展计划资助项目(项目编号:20020632)

摘　　要：提出了电极圆锥内螺纹的图像处理及检测方法。原始灰度图像为CCD采集的经过工件轴线的截面图像,该截面为一个特殊加工的剖分式轴截面,其定位与加工方法同电极内螺纹一样,以此作为抽检来判别电极圆锥内螺纹的几何参数及刀具磨损状况,通过对直径的测量,获得了刀具磨损的相关信息。图像处理过程包括几何变换、灰度级变换、图像平滑、滤波降噪、阈值选取及二值化、边缘提取等,并对不同处理方法进行了比较。在测量尺寸时,使用自编程序计算测量内螺纹的螺距、牙型半角及锥角,测量精度分别达到±0.012mm、±0.17°和±0.018°,满足产品的技术要求,并分析了误差产生的原因。A method of the image processing and measurement of the internal taper thread was proposed. Original gray level image was a section image collected by CCD through work piece's axes. The section was a special machined apart section crossed axes, and its orientation and processing method were the same as internal thread of electrode. According to the section image, the geometry parameters of the work piece and cutter's abrasion status were judged, and relevant information of cutter's abrasion by measuring the middle diameter of the work piece was obtained. Image processing mainly dealt with gray-scale transformation, image smoothing and filtering, noise reducing, threshold selecting, binary image, edge detecting and its extracting et al, different processing methods were compared. When measuring, based on the segmented contour line of thread, we used the compiled measurement program to calculate and measure the geometrical parameters of the internal taper thread as pitch, half of thread angle and taper angle. Precisions of pitch, half of thread angle and taper angle reached ±0.012 mm, ±0.17° and ±0.018°. The results satisfied with the technique requirement of production. The reason of error was analyzed.

关 键 词：电极圆锥内螺纹 图像处理 非接触测量 检测方法 

分 类 号：TG85[金属学及工艺—公差测量技术]