检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:刘景汉[1] 周俊[1] 欧阳锡林[1] 李锡金[1] 卢发强[1]
机构地区:[1]解放军总医院输血科,解放军临床输血中心北京100853
出 处:《中国实验血液学杂志》2005年第4期698-702,共5页Journal of Experimental Hematology
基 金:国家自然科学基金资助项目;编号30271443
摘 要:本研究以建立血小板负载海藻糖基本技术为基础,进一步优化海藻糖负载技术,包括负载温度、负载时间、海藻糖负载浓度和负载溶液。通过比较缓冲液和血浆负载效果,比较生理温度(37℃)和相变温度(16℃)下血小板胞内海藻糖浓度与负载时间曲线、血小板平均体积(MPV)与负载时间、海藻糖负载浓度的曲线、计算海藻糖的负载率,优选负载率较高的负载溶液、负载温度、负载时间和海藻糖浓度等血小板海藻糖负载技术参数。结果表明:37℃血浆负载率高于缓冲液负载率,且血浆负载4小时,在37℃海藻糖负载率可高达19.51%,明显高于16℃的负载率6.16%;血小板MPV在16℃比在37℃明显增大43.2%,随海藻糖负载时间(1-4小时)延长和负载浓度(0-100mmol/L)增加未见明显改变;血小板MPV在37℃与海藻糖负载时间和负载浓度呈正相关性,且海藻糖负载时间与负载浓度存在协同效应,海藻糖负载浓度高于50mmol/L,MPV随浓度(0-100mmol/L)、负载时间(1-4小时)增加而增大。结论:在原血浆中负载海藻糖、温度37℃、时间4小时、浓度低于50mmol/L可以作为优化后血小板海藻糖负载技术基本参数,负载浓度需根据冻干保存需要进行调整。This study was aimed to further optimize trehalose loading technique including loading temperature,loading time, loading solution and loading concentration of trehalose, based on the established parameters. Loading efficiency in plasma was compared with that in buffer at 37℃ ; the curves of intracellular trehalose concentration versus loading time at 37℃ and 16℃ were measured; curves of mean platelet volume (MPV) versus loading time and loading concentration were investigated and compared. According to results obtained, the loaing time, loading tempreture,loading solution and trehalose concentration were ascertained for high loading efficiency of trehalose into human platelet.The results showed that the loading efficiency in plasma was markedly higher than that in buffer at 37℃, the loading eficiency in plasma at 37℃ was significantly higher than that at 16℃ and reached 19.51% after loading for 4 hours, but 6. 16% at 16℃. MPV at 16℃ was increased by 43.2% than that at 37℃, but had no distinct changes with loading time and loading concentration. In loading at 37℃, MPV increased with loading time and loading concentration positively.Loading time and loading concentration displayed synergetic effect on MPV. MPV increased with loading time and concentration while trehalose loading concentration was above 50 mmol/L. It is concluded that the optimization parameters of trehalose loading technique are 37℃ ( temperature), 4 hours ( leading time), plasma ( loading solution),50 mmoL/L (feasible trehalose concentration). The trehalose concentration can be adjusted to meet the requirement of lyophilization.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.15