检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:顾黎明 孙葆根 申超波 卢平 王季刚 王晓辉 唐雷雷 肖云云
出 处:《强激光与粒子束》2010年第12期2964-2968,共5页High Power Laser and Particle Beams
基 金:国家自然科学基金项目(10675118,10875117);中国科学技术大学研究生创新研究基金项目
摘 要:为了克服现有双丝型检测器无法进行水平、垂直两个方向同时测量同步光位置的缺点,合肥光源新研制了基于四象限光位置检测器的同步光位置测量系统,并使用对数比处理技术进行后续的数据处理。通过分别对光学成像系统和四象限光位置检测器的标定,最终得到基于四象限光位置检测器的光位置测量系统的性能参数为:水平方向灵敏度0.471 2 mm-1,线性范围为±1.83 mm,垂直方向灵敏度0.635 0 mm-1,线性范围±1.32 mm。与合肥光源现有的光位置测量系统相比,具有较高的性价比。In order to overcome the limitation that the two-wire monitor cannot measure the beam position in vertical and horizontal directions at the same time, a new photon beam position measurement system based on four-quadrant detector has been developed at the Hefei Light Source(HLS), and the logarithmic ratio method is used for data processing. After the calibration of the optical imaging system and the four-quadrant detector, main parameters of the photon beam position measurement system were obtained. In horizontal direction, the linear range is ±1.83 mm, and the sensitivity is 0.4712 mm-1. In vertical direction, the linear range is ±1.32 mm, and the sensitivity is 0.6350 mm-1. The system has a good performance price ratio.
关 键 词:四象限 光位置检测器 同步光 位置测量系统 based measurement system 线性范围 合肥光源 灵敏度 光学成像系统 性能参数 水平方向 数据处理 垂直方向 处理技术 测量同步 mm-1 性价比 对数比 研制
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.15