日本在软接触电磁连铸方面的最新研究进展  

Recent Development of Research on Soft-contact Electromagnetic Continuous Casting of Japan

作　　者：杨健[1] 陈崇峰[1] 

机构地区：[1]武汉科技大学材料与冶金学院,湖北武汉430081

出　　处：《钢铁钒钛》2005年第3期44-47,63,共5页Iron Steel Vanadium Titanium

基　　金：湖北省教育厅科学研究资助项目(2001A19014)

摘　　要：主要介绍了软接触电磁连铸的原理和日本最近几年来在软接触电磁连铸方面的研究进展,分析了电流强度、焦耳热、结晶器形状和早期凝固壳形态对铸坯表面质量的影响,提出了该技术还需进一步研究的关键问题。分析认为:感应线圈产生的焦耳热是决定铸坯表面质量的首要因素;电流强度存在一个最佳值,过大或者过小均会对铸坯表面质量产生不利影响;连铸条件相同时,角部形状为圆角的结晶器所生产出来的铸坯表面质量要好于角部形状为直角的结晶器。The principle of soft - contact electromagnetic continuous casting and the recent research development in Japanese were introduced. The influence of coil current, Joule heat, the Shape of the mold and the early - solid/tied shell on surface quality of strand was discussed. The problems that should be noticed in future were presented. The following views are concluded. The Joule heat produced by induction coil is the chief influence factor of strand surface quality. There is an optimum coil current, otherwise, it would have unfavorable effect on the surface quality of strand. With same technological parameters, the surface quality of strand produced by round angle mould is better than by right angle mould.

关 键 词：连铸 焦耳热 振痕 结晶器 表面质量 

分 类 号：TG249.7[金属学及工艺—铸造]