印刷电路板显影废水处理研究  

Study on the treatment of development wastewater from PCB production

作　　者：鲍旭平[1] 李义久[1] 

机构地区：[1]同济大学化学系,上海200433

出　　处：《工业水处理》2005年第11期22-24,共3页Industrial Water Treatment

摘　　要：印刷电路板生产中产生的显影废水是一种高有机物含量、成分复杂、难以生化降解的废水。作者采用酸化破乳—铁炭微电解—中和沉淀—SBR组合工艺处理该废水,并通过实验确定最佳工艺参数:酸化破乳pH为3～4,破乳后出水进入铁炭微电解柱,V(铁)∶V(炭)=11∶,反应时间为45 min,出水加石灰乳调节pH为7～8,中和沉淀;SBR每12h为一个周期,最佳反应时间为8h。经组合工艺处理后,原废水CODCr由原来的11 000mg/L降至400 mg/L左右,去除率达到96%左右。The development wastewater from PCB production is complex and difficult to be degraded and contains organic substances with high concentration. The combined processing method of acidified demulsification - micro electrolysis of iron and carbon - neutralized sedimentation - SBR is used for treating this kind of wastewater. And the optimal technological conditions are ascertained by experiments. The pH value of acidified demulsification is 3 - 4 ; VFe ： Vc is 1 ： 1 in the Fe/C column, and the reaction time of micro electrolysis is 45 min ; then the effluent is neutralized by Ca（OH）2 solution to pH 7 - 8; in SBR reaction, 12 h per cycle and the optimal reaction time is 8 h. After the whole treatment, the CODcr of the inlet water is reduced from 11 000 mg/L to 400 mg/L and the total CODcr removal rate reaches about 96%.

关 键 词：破乳 铁炭微电解 序批式间歇反应器 显影废水 

分 类 号：X703.1[环境科学与工程—环境工程]