6.65 W输出二极管抽运双包层光纤单频放大器  

6.65 W Output of LD-Pumped Double-Clad Fiber Single-Frequency Amplifier

作　　者：孙文峰[1] 赵长明[1] 杨苏辉[1] 李磊[1] 

机构地区：[1]北京理工大学信息科学技术学院光电工程系,北京100081

出　　处：《北京理工大学学报》2006年第1期60-62,共3页Transactions of Beijing Institute of Technology

基　　金：国家部委预研项目(41302010107)

摘　　要：研究光纤放大器的耦合效率以及影响输出功率的因素.抽运源为光纤输出976 nm的半导体激光器,增益光纤为长4.4 m的D型掺Yb3+双包层光纤,信号源为自行研制的单块非平面环形腔激光器.抽运光的耦合效率为80%,信号光的耦合效率为44%,入纤抽运光功率为24 W,信号光功率为200 mW时,得到了6.65 W的净输出功率,放大倍数达到33倍.分别对信号光及放大输出的频谱进行测量,结果为1 064 nm的单频放大.实验表明,信号光对放大增益的抽取非常重要,在此实验中信号光尚未饱和,放大功率仍有提高的余地.The coupling efficiency of the amplifier and the factors affecting the output power improvement are investigated. The pumping source is a fiber coupled laser diode array with radiation at 976 nm, and the gain medium is a D-shaped double-clad fiber with the length of 4.4 m, The signal laser is a non-planar ring oscillator. The coupling efficiency for pump and signal are 80% and 44%, respectively. Output power 6.65 W was obtained when the launched pumping power is 24 W and the signal power is 200 mW. In experiment, the input signal was not saturated, so the amplification has the potential to be improved.

关 键 词：二极管抽运 双包层光纤 单频放大 

分 类 号：TN242[电子电信—物理电子学] TN248.1