镍纳米粉的阳极弧等离子体制备工艺条件与性能研究  

Study on the process conditions and performance of Ni nanopowders prepared by anodic arc plasma

作　　者：魏智强[1] 乔宏霞[2] 冯旺军[1] 戴剑锋[1] 王青[1] 李维学[1] 闫鹏勋[3] 

机构地区：[1]兰州理工大学理学院,甘肃兰州730050 [2]兰州理工大学土木工程学院,甘肃兰州730050 [3]兰州大学物理科学与技术学院,甘肃兰州730000

出　　处：《材料科学与工艺》2006年第1期71-74,共4页Materials Science and Technology

基　　金：甘肃省自然科学基金资助项目(3ZS042-B25-017);甘肃省科技攻关基金资助项目(GS012-A52-047)

摘　　要：为了研究阳极弧放电等离子体方法在制备镍纳米粉过程中电弧电流、气体压力等工艺参数对纳米粉产率及粒度的影响,寻求制备金属纳米粉的最佳工艺参数.利用X射线衍射(XRD)、透射电子显微镜(TEM)和相应选区电子衍射(ED)、BET吸附等测试手段对样品的形貌、晶体结构、粒度分布、比表面积等性能进行了表征.研究结果表明:本法所制得的镍纳米粉的晶格结构为fcc结构.呈规则的球形链状分布,适当控制工艺参数就能制取粒径范围在20-100nm的金属纳米粉,在其他工艺参数不变条件下,气压升高或电弧电流增大,都会使粒度增大,产率增大.The influence of arc current and gas pressure on the production rate and particle size of metal nanopowders by anodie are diseharged plasma method were studied, and the optimal teehnology parameters were obtained. The nanopartieles by this process were characterized by X -ray powder diffraction （XRD）, transmission electron microscopy （TEM） the corresponding selected area electron diffraction （SAED） , BET adsorption to determine the morphology, erystal mierostrueture, partiele size distribution, speeifie surfaee area. The experimental results indieated the erystal strueture of Ni nanopowders was fee phase, and distributed uni- formly in spherical chain shapes. Properly controlling some experimental apparatus can obtain Ni nanopowders with particle size ranging from 20nm to 100nm. The yield and particle size go up with the raise of are current or gas pressure when other faetors are fixed.

关 键 词：阳极弧等离子体 纳米粉 性能 工艺参数 

分 类 号：TG146.15[一般工业技术—材料科学与工程]