基于平面圆形薄板结构的光纤FBG动态压力传感器  

Research on the Fiber Bragg Grating Dynamic Pressure Sensor Based on Planar Circular Sheet Structure

作　　者：王俊杰[1] 姜德生[1] 谢官模[1] 梁宇飞[1] 李军向[1] 黄俊斌[2] 

机构地区：[1]武汉理工大学光纤传感与信息处理教育部重点实验室,武汉430070 [2]海军工程大学兵器工程系,武汉430033

出　　处：《武汉理工大学学报》2006年第3期89-92,共4页Journal of Wuhan University of Technology

基　　金：国家"973"重大基础研究项目(51361ZT2)

摘　　要：提出了基于平面圆形薄板结构光纤光栅（FBG）动态压力传感器的实现方法，从理论上分析了其静态灵敏度和动态频率响应特性，并且采用振动液枉法和电磁力发生器对其灵敏度和动态特性进行了实验研究。平面薄板采用不锈钢材质、厚度为0．15mm、直径为15mm，对于该尺寸结构的传感嚣，静态灵敏度可达0．02pm／Pa，比裸光栅增敏6300倍，谐振频率为78kHz，而且幅频特性在0-6．5kHz频率范围内较为平坦．研究表明：对该结构薄板的几何尺寸进行适当的调整，可实现不同量程、不同带宽的压力测量。This paper put forward the FBG dynamic pressure sensing principle and analyze the static response .sensitivity and dynamic frequency response characteristic of this sensor. The static sensitivity and dynamic characteristic test based on vibration liquid columm method and electromagnetism force generator were researched. Planar sheet adopt stainless steel, its thickness is 0.15 mm, and its diameter is 15 mm. For this size of the structure, the sensor static sensitivity was up to 0.02 pm/Pa, which was about 6 300 times the value of the bare fiber, the resonance frequency was 7.8 kHz, and the amplitude-frequency curve was relatively flat during the frequency range 0-6.5 kHz. Research showed that this sensor can realize different bandwidth, differ ent range pressure measurement by adjusting the geometrical size of the sheet.

关 键 词：光纤传感嚣 光纤光栅 动态压力测量 平面薄板结构 

分 类 号：TN253[电子电信—物理电子学]