检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]清华大学建筑玻璃与金属结构研究所清华大学结构工程和震动教育部重点实验室,北京100084 [2]晶艺特种玻璃工程有限公司,北京100045
出 处:《建筑科学》2006年第2期23-26,共4页Building Science
摘 要:单层索网幕墙是一种新型的点支式柔性玻璃幕墙体系,因其具有通透性好、轻盈美观和施工灵活等特点得到广泛应用。但是在设计分析时需要考虑预应力和几何非线性大变形的影响,难度有所增加。参照北京新保利大厦二期工程单层索网玻璃幕墙,于清华大学结构工程实验室建立了1∶10比例的试验模型。本文采用有限元分析软件ANSYS对含主次索的复杂单层索网模型在水平荷载作用下的变形性能进行分析,并比较预应力和玻璃刚度的影响。通过有限元分析结果和试验数据的对比,验证有限元计算方法和结果的可靠性,为实际工程设计提供依据。Single-layer cable net is a new kind of flexible point-supporting system and has been used widely for its fine transparence, light weight and flexible construction etc. But it brings lots of difficulties in the design and the analysis of cable net because of the influence of prestress and large deflection. Referring to the design of single-layer cable net of beijing new baoli mansion ,a 1 : 10 test model was devised in the structural engineering laboratory of Tsinghua University. This article analyses the deflection performance of complex single-layer cable net model under the horizontal load by the finite element analysis software -ANSYS. The influences of prestress and glass stiffness are considered. Comparing the analysis results by the finite element analysis software with the experimental data, the authors verify the reliability of the methods and the results of the finite element model and give some important references to the design of the real project.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.226.88.145