检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:赵干卿[1] 李富强[2] 陈松涛[1] 闫永胜[1] 谢吉民[1]
机构地区:[1]江苏大学化学化工学院 [2]平顶山工学院基础部,河南平顶山467000
出 处:《化学试剂》2006年第6期345-348,共4页Chemical Reagents
摘 要:在酸性条件下,Fe(Ⅲ)和Mo(Ⅳ)可与邻苯二酚生成有色配阴离子Fe(Ⅲ)-邻苯二酚体系和Mo(Ⅳ)-邻苯二酚体系,该二配阴离子易与Cl-型717#阴离子交换树脂中的Cl-进行等离子对交换缔合,形成三元等离子对缔合体系R+(阴离子交换树脂)-Fe(Ⅲ)-邻苯二酚体系和R+-Mo(Ⅳ)-邻苯二酚体系.两种三元缔合体系的最大吸收波长分别为520和402nm,与水相中最大吸收波长相同,对比度△λ=118nm,互不干扰,故而建立了薄层树脂相光度法同时测定Fe(Ⅲ)和Mo(Ⅳ)的新方法.方法灵敏度高,εFe520(Ⅲ)=4.8×10^4L·mol^-1·cm^-1,比水相光度法提高16倍,εMo402(Ⅳ)=1.0×10^5L·mol^-1·cm^-1,比水相光度法提高24倍;精密度理想;选择性强.实测了合成水样和天然水样中Fe(Ⅲ)和Mo(Ⅳ),加标回收率分别为97%~99%和97%~101%,检出限分别为35和28ng/mL,线性范围分别为0~12和0~9.6μg/mL.与AAS法测定值相比较,结果令人满意.A new method for the determination of Fe( Ⅲ ) and Mo ( Ⅳ ) by fin layer resin phase spectrophotometer was developed. The colored complexes anion is formed by Fe( Ⅲ ) and Mo( Ⅳ ) with 1,2-benzendiol.These coordination compound can exchange with Cl^- on the surface active sites of model 717 cation exchange resin, and complexes were concentrated on 717 ^# resin( R ^+ ) in lower acidic aqueous solution. The system of R^+ -Fe( Ⅲ )-1,2- benzendiol and R ^+ -Mo( Ⅳ )-1,2-benzendiol were prepared. The maximum absorption wavelength of R^+ -Fe ( Ⅲ )-1,2-benzendiol and R^+ -Mo( Ⅳ )-1,2-benzendiol is at 520nm and 402nm, respeetively, as same as that in the water phase. The contrast ( △λ ) is is about llSnm. The apparent molar absorptivity (ε520^Fe(Ⅲ) )4.8 × 10^4L· mol^-1· cm^-1 which is about 16 times higher than in the aqueous phase, and the apparent molar absorptivity ( ε402^Mo(Ⅳ) ) is 1.0 × 10^5L·mol^- 1·cm^-1 ,which is about 24 times higher than that in the aqueous phase. It has an ideal precision (7.0μg Fe (Ⅲ),n =6,RSD= 1.41%;7.0μg Mo(Ⅳ), n =6, RSD = 1.67%) .Beer's law was obeyed in the range of 0- 12μg/mL and 0 - 9.6μg/mL for Fe( Ⅲ ) and Mo( Ⅳ ) respectively. It has a good selectivity for this method, Fe( Ⅲ ) and Mo( Ⅳ ) were determined in synthetic water sample and natural water. The recoveries determined by standard addition method for Fe( Ⅲ ) and Mo( Ⅳ ) are 97% - 99% and 97% - 101% respectively. The detection limit of Fe( Ⅲ ) and Mo( Ⅳ ) are 35ng/mL and 28ng/mL respectively.
关 键 词:薄层树脂相吸光光度法 测定 Fe(Ⅲ) Mo(Ⅳ)
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.62