碱性污水生物催化氧化预处理工业试验  

COMMERCIAL TESTS FOR ALKALINE WASTEWATER TREATMENT BY BIOLOGIC CATALYTIC OXIDATION

作　　者：程丽华[1] 陈建军[2] 刘洪波[2] 钟华文[1] 谭国强[3] 

机构地区：[1]茂名学院,广东省茂名市525000 [2]苏州大学,江苏省苏州市215000 [3]中国石化茂名炼油化工股份有限公司,广东省茂名市525000

出　　处：《炼油技术与工程》2006年第7期59-62,共4页Petroleum Refinery Engineering

基　　金：中国石油化工集团公司资助项目(A01122)

摘　　要：采用生物催化氧化预处理新工艺对炼油厂的碱性污水进行工业试验。结果表明:二级生物催化氧化反应工艺比单级氧化反应工艺效果好。当炼油厂碱性污水CODcr为500-4 500 mg／L,硫化物为94-800 mg／L,挥发酚为70-800 mg／L时,采用二级生物催化氧化工艺,在水力停留时间HRT=3-6 h,曝气量为16 m3／h条件下,碱性污水的硫化物去除率平均可达95％以上,出水中硫化物浓度仅为3 mg／L左右,CODcr、酚和油的去除率均达60％以上,达到了预处理目的。工业试验为工艺设计和工业运行提供了有关操作参数。Commercial tests of treating refinery alkaline waste water by biologic catalytic oxidation have been performed. The results show that the two-stage process is better than the single-stage. When the sulphide, COD and the concentration of phenol in the alkaline wastewater were 94 - 800 mg/L, 500 - 4 500mg/ L and 70 - 800 mg/L respectively and when the hydraulic retention time was 3 - 6 h and the aerating rate was 16 m3/h. , 95% of shulphides was removed, the sulphide of effluent water was only 3 mg/L and the removal rate of CODer, phenol and oil was over 60%. The commercial tests provide valuable operating parameters for process design and commercial operation.

关 键 词：碱性污水 生物催化氧化 预处理 工业试验 

分 类 号：X742[环境科学与工程—环境工程]