矩形盒拉深成形的数值模拟与实验  

Numerical simulation and experiment of deeply drawing-formed box

作　　者：王元勋[1] 王书恒[1] 沈为[1] 李荣峰[2] 

机构地区：[1]华中科技大学土木工程与力学学院,湖北武汉430074 [2]武汉钢铁公司技术中心,湖北武汉430080

出　　处：《华中科技大学学报（自然科学版）》2006年第12期80-82,共3页Journal of Huazhong University of Science and Technology(Natural Science Edition)

基　　金：国家自然科学基金资助项目(10272050)

摘　　要：建立了矩形盒拉深成形的有限元三维模型,对其进行了数值模拟分析,并把数值模拟结果和实验结果进行了对比分析,讨论了在有限元数值模拟过程中虚拟冲压速度对模拟结果的影响,发现增加虚拟冲压速度会带来系统的惯性效应,当虚拟冲压速度大于一定值时,会使模拟结果严重失真.板材拉深数值模拟时最大虚拟冲压速度建议设定在2 000 mm/s范围内.The 3D finite-element analysis model is established for the rectangle box deep drawing. The box deep drawing process was simulated and analyzed with the Ls-Dyna. Comparing the numerical simulation results with that of the experiment, the preciseness and validity for solving the box deep drawing problems by the finite-element numerical simulation method has been validated. The effect of virtual punch velocity on the result of simulation is also discussed. Inertia reaction of the system would be incident with the increasing of the virtual punch velocity and the simulation results would be distortion if the virtual punch velocity exceeds a certain value. The maximum virtual punch velocity for the sheet metal drawing simulation may not exceed 2 000 mm/s.

关 键 词：数值模拟 拉深成形 虚拟冲压速度 

分 类 号：O32[理学—一般力学与力学基础]