检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:龚方红[1] 蒋正静[1] 魏旭[1] 汪信[1] 陆路德[1] 杨绪杰[1]
机构地区:[1]南京理工大学化工学院
出 处:《合成树脂及塑料》2007年第1期64-67,共4页China Synthetic Resin and Plastics
基 金:江苏省自然科学基金资助(BK2002100);江苏省高校自然科学基金资助项目(05KJB430024)。
摘 要:采用傅里叶变换红外光谱(FTIR)和Raman光谱表征了硅烷接枝线型低密度聚乙烯(LLDPE)的结晶结构。用FTIR和Raman光谱上硅烷特征峰与LLDPE亚甲基峰的强度比,可相对比较硅烷接枝LLDPE的接枝率,随着硅烷用量的增加,由FTIR计算的吸光比从0.96增至2.62,由Raman光谱计算的强度比从11.53增至14.00,两者的变化趋势相同。Raman光谱分析还表明,随着硅烷用量的增加,硅烷接枝聚乙烯的结晶相质量分数由57.58%降至46.99%,非晶相质量分数由11.58%升至16.52%,中间相质量分数从30.84%升至36.48%。The crystal structure of silane grafted hnear low density polyethylene (LLDPE) was characterized by Fourier transform infrared spectroscopy (FTIR) and Laser Raman Spectroscopy. The graft ratio of LLDPE grafted by silane could be compared relatively based on the intensity ratio of characteristic peaks of silane to methylene peak of LLDPE in FTIR and Raman spectrum. As the silane content increased, the absorption ratio calculated in terms of FTIR spectrum rose from 0.96 to 2.62 and the same ratio figured out in accordance with Raman spectrum went up from 11.53 to 14.00, showing the identical tendency of variation in the respective calculation. In addition, the analysis by Raman spectroscopy further revealed that with increasing silane dosage, the mass fraction of crystal phase in silane grafted LLDPE lowered from 57.58% to 46.99%, whereas the mass fraction of amorphous phase and mesophase augmented from 11.58% to 16.52% and from 30.84% to 36.48%, respectively.
关 键 词:线型低密度聚乙烯 硅烷 接枝 结晶 Raman光谱傅里叶变换红外光谱
分 类 号:TQ325.12[化学工程—合成树脂塑料工业]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.30