检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
出 处:《工程力学》2007年第3期42-47,共6页Engineering Mechanics
基 金:国家自然科学基金资助项目(50171054);航空科学基金资助项目(01H53066)
摘 要:着重研究了微动桥足不同几何形状——方足(r=0mm)及带不同半径r(0.3mm、0.6mm、0.9mm)对微动区接触应力的影响,用不同的r值模拟微动桥足在微动疲劳中的磨损状况。采用ANSYS有限元分析软件详细计算了接触表面的应力分布和磨损区、粘着区、滑动区及张开区的大小,进而讨论裂纹的萌生位置,并建立了不同的r大小即磨损状况与裂纹萌生位置的关系。同时针对方足微动桥/平面试件的接触几何,计算了不同名义接触压力分布形式对接触面上应力分布的影响。此外,还对方足微动桥/平面试件接触几何进行了三维有限元分析,证明了萌生裂纹通常是以多源方式同时出现。计算结果与实验结果吻合很好。The influence of different geometry shapes of fretting-bridge foot (r=0mm for rectangular and r= 0.3mm, 0.6mm, 0.9mm) on the distribution of contact stresses was mainly investigated. Using the different values of r to simulate the wear of the fretting-bridge foot, the distribution of contact stresses and the zone with wearing, sticking, sliding and opening on contact surface were calculated in details using finite element program ANSYS. After analyzing the nucleating locations of cracks, the relationship of different values of r, which represented wear, and nucleating locations of crack were established. For the contact geometry of a specimen contacting with a rectangular fretting bridge, the influence of distribution of nominal contact pressure on stresses of contact surface was also calculated. A three dimensional finite element method was used to analyze the contact stress distribution of a specimen contacting with a rectangular fretting bridge. The results show that several cracks usually nucleated simultaneously on the contact surface. The analysis results were in good agreement with the experimental ones.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.144.226.114