检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]热科学与动力工程教育部重点实验室,清华大学热能工程系,北京100084
出 处:《工程热物理学报》2006年第5期823-825,共3页Journal of Engineering Thermophysics
基 金:国家杰出青年科学基金资助项目(No.50025617);清华大学基础研究基金项目资助(No.JCpy2005049)
摘 要:本文对空气流过烧结微细多孔介质内部的对流换热进行了实验研究。实验段为烧结多孔介质,颗粒的平均直径为0.2 mm。通过“单吹法”的实验方法进行瞬态实验,并用两种不同的数据处理方法得到了多孔介质内部对流换热系数。数据处理方法1利用局部非热平衡能量方程,结合实验数据,数值求得了多孔介质内部对流换热系数。方法2利用实验数据直接求得内部对流换热系数。研究表明:用数据处理方法1得到的多孔介质内部对流换热系与用方法2得到的结果相差在10%以内,与已有结果基本吻合。Heat transfer between solid particles and fluid in a mini-porous media was studied experimentally. The test section was sintered bronze porous media and the average particle diameter was 0.2 mm. The heat transfer coefficient in the mini-porous media is determined experimentally using a transient single-blow technique. Two different methods to obtain the heat transfer coefficients were used such as the method of one dimensional numerical calculation based on the experimental data (method 1) and the method directly using the experimental data (method 2). The experimental results for the heat transfer coefficients using the method 2 were higher than the results using the method 1 by 10%.
分 类 号:TK124[动力工程及工程热物理—工程热物理]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222