两段式无缝软接触结晶器电磁参数和结构参数的研究  

STUDY ON ELECTROMAGNETIC AND STRUCTURAL PARAMETERS IN TWO-STAGE SOFT CONTACT SLIT-LESS MOLD

作　　者：金百刚[1] 王强[1] 崔大伟[1] 刘燕[1] 赫冀成[1] 

机构地区：[1]东北大学材料电磁过程研究教育部重点实验室,沈阳110004

出　　处：《金属学报》2007年第4期427-432,共6页Acta Metallurgica Sinica

基　　金：国家高技术研究发展计划项目2001AA337040;辽宁省科技厅科技攻关项目2006221007;高等学校学科创新引智计划项目B07015资助

摘　　要：利用数值模拟与正交实验相结合的方法,研究了两段式无缝软接触结晶器壁厚(d)、结晶器上半段电阻率(ρ)、电源频率(f)、线圈电流强度(I)对结晶器透磁效果的影响规律．结果表明:结晶器内部磁感应强度(B)随f和d的增大而减小,随I和ρ的增大而增强．各因素对磁场影响的顺序依次为f,ρ,I,d．通过无量纲分析确定了两段式结晶器内弯月面处B与d,ρ,f,I之间的定量关系为B/(μ_0I/d)．=4．36×10~9(ρ/If)^(0.89)．最后,确定了两段式结晶器应用于软接触技术最佳的实验条件为:d=5 mm,p=8．8×10^(-7)Ω·m,I=2000 A,f=2500 Hz．Numerical simulation and orthogonal experiment were used to study the effects of some factors, such as thickness of mold wall （d）, resistivity of the top half of the mold （ρ）, electrical frequency （f） and coil current intensity （I）, on the penetration of magnetic field in two-stage soft contact electromagnetic continuous casting slit-less mold. The magnetic flux density （B） is decreased with increasing f and d, but increased with increasing ρ and I. The order of factors affecting the penetration of magnetic field in two-stage mold is f, ρ, I, d. By dimensionless analysis, the relation between B and above four parameters was given as B/（μ0I/d）=4.36× 10^9 （ρ/If）^0.89. Finally, the ideal parameters of two-stage soft contact electromagnetic continuous casting mold were obtained： d=5 mm, ρ=8.8×10^-7 Ω·m, I=2000 A, f=2500 Hz.

关 键 词：软接触电磁连铸 两段式结晶器 结构参数 电磁场 数值模拟 

分 类 号：TG113.22[金属学及工艺—物理冶金]