套管膨胀性能试验研究  

Experimental Research on Expandable Casing

作　　者：王旱祥[1] 王艳红[1] 于桂杰[1] 蔡庆俊[2] 张全胜[2] 

机构地区：[1]中国石油大学(华东)机电工程学院,山东东营257061 [2]胜利油田有限公司采油工艺研究院,山东东营257000

出　　处：《石油矿场机械》2007年第5期61-63,共3页Oil Field Equipment

基　　金：中国石油天然气集团公司创新基金(2003E7024)

摘　　要：利用10 mm×30°和10 mm×45°倒角的膨胀头对J55和N80两种φ114.3 mm(41/2英寸)套管进行了膨胀试验,结果表明,30°倒角膨胀头膨胀套管所需的力小于45°倒角的膨胀头;套管膨胀过程中出现3次峰值载荷;J55套管比N80套管易膨胀,J55套管膨胀后的壁厚减薄率大于N80套管,而长度缩短率小于N80套管。An expandable experimentation of both J55 and N80 steel φ114.3 mm （41/2 inch） casing was carried on with 10 mm×30°and 10 mm×45°chamfered expandable cone. The result shows that the force required by the expandable casing with the 30° chamfered cone is less than that required by the 45° chamfered cone. And also three load peak values which appeared in the expandable course are found. The experimentation finally proves that J55 steel casing is easier to be expanded than N80 steel casing and its wall thickness reduction ratio is bigger than the N80 steel easing＇s while its length shortening ratio is smaller than the N80 steel casing＇s.

关 键 词：套管 膨胀 力学性能 试验 

分 类 号：TE931.207[石油与天然气工程—石油机械设备]