垂直上升内螺纹管中超超临界压力水的传热特性研究  

Investigation on Heat Transfer Characteristics of Ultra-Supercritical Water in Vertical Upward Internally Ribbed Tube

作　　者：王为术[1] 罗毓珊[1] 陈听宽[1] 顾红芳[1] 朱晓静[1] 王海涛[1] 吉庆[1] 

机构地区：[1]西安交通大学动力工程多相流国家重点实验室

出　　处：《核动力工程》2007年第3期43-46,60,共5页Nuclear Power Engineering

基　　金：国家自然科学基金重大资助项目(50323001);国家863项目(2002AA526012)

摘　　要：在P=25～35MPa、G=450～1800kg/(m2.s)、q=200～600kW/m2的试验参数范围内,研究了φ28.6×5.8mm垂直上升内螺纹管内水的传热特性及管壁温分布。试验结果表明:在超临界及超超临界压力区,垂直上升内螺纹管对水的传热在拟临界点前后不同,在低焓区管壁温度随焓增平缓增加,管壁温度在临界焓值区存在跃升;质量流速的提高可强化传热、推迟壁温跃升,但热负荷的增加有相反的作用。文中还给出了超超临界压力区适用于不同焓值范围的换热系数试验关联式。In ultra-supercritical pressure region, the heat transfer characteristics of water in a vertical upward internally ribbed tube with the diameter of φ28.6×5.8mm have been experimentally investigated. The tests have been performed under various conditions with the pressure ranging from 25 to 35Mpa, the mass velocity from 450 to 1800 kg/（m^2-s）, and the internal wall heat flux from 200 to 600 kW/m^2. The results show that the heat transfer of ultra-supercritical water is better below the pseudo-critical point than that above the pseudo-critical point. Increasing the mass velocity can improve the heat transfer of ultra-supercritical water with a much stronger effect below the pseudo-critical point than that above the pseudo-critical point. The pressure has only a moderate effect on the heat transfer of ultra-supercritical water when the temperature of water is below the pseudo-critical point. Sharp rising of inner wall temperature near the pseudo-critical region takes place earlier at a higher pressure. For given pressure and mass velocity, the internal wall heat flux also shows a significant effect on the distributing of inner wall temperature. The inner wall temperatures are higher at a higher heat flux. Increasing of internal wall heat flux leads to an early occurrence of sharp rising of the wall temperature. Based on the experiments, correlations of heat transfer coefficients are also presented for the vertical upward internally ribbed tubes.

关 键 词：垂直管 内螺纹管 超超临界压力 传热 

分 类 号：TK124[动力工程及工程热物理—工程热物理]