一次模压成形生产的高性能NdFeB径向多极环  

High Performance Sintered NdFeB Radially Oriented Multi-pole Ring Magnet Produced by Single Molding Process

作　　者：刘兴民[1] 方以坤[1] 李岫梅[1] 李卫[1] 

机构地区：[1]钢铁研究总院,北京100081

出　　处：《磁性材料及器件》2007年第3期50-51,62,共3页Journal of Magnetic Materials and Devices

基　　金：国家自然科学基金资助项目(50571028);北京市重点课题资助项目(D0406002000091)

摘　　要：分别用模压+等静压二次成型和一次模压成形工艺制备了烧结钕铁硼多极磁环,用NIM-2000测量了样品的磁性能,用磁力显微镜观测了取向方向和垂直去向方向的磁畴结构,用多极环与导磁环构成磁路测试了各极的气隙磁场。结果表明,一次成型比二次成型制备的多极环气隙磁场高,而且各极的磁密均匀度也要优于二次成型工艺制备的多极环,同时,一次成型工艺简单,因此有利于制备高性能的多极环。Sintered NdFeB radially oriented multi-pole ring magnets were prepared by single molding process and molding followed by subsequently isostatic compaction. The magnetic property was measured by NIM-2000 autohysteresis loop and the magnetic microstructures of cross section of the ring was observed by magnetic force microscopy （MFM）. The air-gap field of the multi-pole ring set in iron ring was measured. It shows that the magnetic performance and uniformity of multi-pole ring prepared by single molding is higher than that of magnet prepared by two step molding. So, single molding is an effective process to prepare radially oriented multi-pole ring magnet not only for its simplicity but also for high magnetic performance and uniformity of the magnet.

关 键 词：径向取向NdFeB多极磁环 一次模压成型 模压+等静压二次成型 磁性能 均匀性 

分 类 号：TM273[一般工业技术—材料科学与工程] TF124.3[电气工程—电工理论与新技术]