钠钾工质碱金属热电转换器发电组件制备关键技术的研究  

STUDY ON FABRICATING POWER GENERATING MODULE OF ALKALI METAL THERMAL-TO-ELECTRIC CONVERTER WITH NAK WORKING FLUID

作　　者：张来福[1] 童建忠[2] 倪秋芽[2] 温兆银[3] 

机构地区：[1]山西电力科学研究院,太原030001 [2]中国科学院电工研究所,北京100080 [3]中国科学院上海硅酸盐研究所,上海200050

出　　处：《太阳能学报》2007年第6期644-647,共4页Acta Energiae Solaris Sinica

摘　　要：提出了钠钾工质碱金属热电转换器的概念,论证了开展钠钾工质碱金属热电转换器基础研究的意义,介绍了NaK-BASE管的制备方法,开展了NaK-BASE管—α-Al_2O_3绝缘过渡件—金属法兰之间的活性焊接和NaK-BASE管外表面电极多孔薄膜的制备等关键技术的探索性试验研究。试验结果表明,NaK-BASE管与α-Al_2O_3管以及α- Al_2O_3管与钛合金件之间的钎缝的漏率均达到10^(10)Pa·m^3/s级以上。采用反应性磁控溅射技术,在NaK-BASE管外表面制备了TiN电极多孔薄膜。The concept of alkali metal thermal-to-electric converter with NaK working fluid （NaK-AMTEC） was presented in this paper, the significance of research on NaK-AMTEC was described, the preparation procedure of NaK-BASE tube was simply introduced, the methods and skills of active brazing was investigated for joining of NaK-BASE tube, α-Al2O3 transition section and metal flange, and the preparation processing of porous electrode film on the outer surface of NaK- BASE tube were explored, too. The results show that both the leak rate through the active brazing layer between NaK- BASE tube and α-Al2O3 transition section, and the one between α-Al2O3 transition section and Ti alloy flange are above the grade of 10^10pa·m^3/s. Thin porous TiN film electrode was deposited on the outer surface of NaK-BASE tube by magnetron sputtering system.

关 键 词：碱金属热电转换器 钠钾工质 发电组件 制备 

分 类 号：TM86[电气工程—高电压与绝缘技术]