浮动铰刀振动铰削小口径火炮身管的研究  

Study on Vibration Reaming of Small Caliber Gun Tube with Auto Aligning Reamer

作　　者：邢立华[1] 江旭初[1] 雷丙旺 李红艳 张德远[1] 

机构地区：[1]北京航空航天大学机械工程及自动化学院,北京100083 [2]内蒙古北方重工业集团有限公司,内蒙古包头014033

出　　处：《兵工学报》2007年第6期739-743,共5页Acta Armamentarii

摘　　要：研究了振动铰削抑制积屑瘤形成的机理,在此基础上通过浮动铰刀振动铰削小口径火炮身管的实验,分析了振动铰削对火炮身管内膛表面粗糙度的影响。振动铰削把普通铰削的连续切削过程转变为断续的脉冲式切削过程,将普通铰削时的螺旋状连续切屑变成了非常细小的针状单元切屑,增强了铰削加工的断屑排屑能力,从根本上抑制了积屑瘤的形成,避免了已加工表面的犁沟和鳞刺。实验表明:振动铰削的表面粗糙度Ra比普通铰削至少提高3级;振动铰削的表面粗糙度Ry不到普通铰削的1/5;振动铰削使孔的已加工表面均匀一致,显著提高了身管内膛的表面质量。The mechanism of suppressing the formation of built-up-edge （BUE） of vibration reaming was studied. The vibration reaming experiments of a small caliber gun tube were carried out by the auto aligning reamer. The influence of vibration reaming on surface roughness of gun tube was analyzect. The continuous cutting process of the conventional reaming was transformed into the pulsed intermittent cutting process, so that the continuous helical chip of the conventional reaming was transformed into the minute acicular cell chip of the vibration reaming. The capability of chip-breaking and chip-removing of reaming was improved, therefore the formation of built-up edge was suppressed, which avoids the generation of plough ditch and scales of hole surface. The experimental results indicate that the surface roughness Ra of the vibration reaming is enhanced at least 3 levels than that of the conventional reaming; and the surface roughness Ry is less than one-fifth of the conventional reaming; The surface quality of gun tube is greatly improved.

关 键 词：机械制造工艺与设备 振动铰削 表面粗糙度 浮动铰刀 火炮身管 表面质量 

分 类 号：TG506.7[金属学及工艺—金属切削加工及机床]