漆酶/丁香酸甲酯处理未漂KP浆的SEM和GPC分析  

The Analysis of SEM and GPC on Laccase/MS-treated Unbleached Kraft Pulp

作　　者：孙兵[1] 石淑兰[1] 刘娜[2] 裴继诚[3] 

机构地区：[1]天津科技大学天津市制浆造纸重点实验室,天津300222 [2]山东轻工业学院山东省制浆造纸科学与技术重点实验室,山东济南250100 [3]华南理工大学制浆造纸工程国家重点实验室,广东广州510641

出　　处：《中国造纸学报》2007年第3期30-34,共5页Transactions of China Pulp and Paper

基　　金：本研究获国家自然科学基金项目(30471359);华南理工大学制浆造纸工程国家重点实验室基金项目(200618)资助。

摘　　要：采用扫描电镜(SEM)和凝胶渗透色谱(GPC)技术,研究漆酶和漆酶/丁香酸甲酯(MS)处理前后未漂硫酸盐浆(KP浆)纤维表面形态结构和浆中木素分子质量及其分布的变化,探讨了用漆酶和漆酶/MS处理KP浆,提高浆张湿抗张强度的相关机理。研究结果表明:与空白样相比,经漆酶处理后,纸浆中木素平均分子质量降低,纤维表面出现"黏结"现象;而MS协同漆酶处理后,纸浆中木素的缩合程度及纤维间的"黏结"面积增大;漆酶和漆酶/MS处理后的浆样再经过加热干燥处理,木素的缩合程度和纤维"黏结"面积进一步增大。木素的缩合程度和纤维表面呈现的"黏结"现象,与漆酶和漆酶/MS处理纸浆提高其湿抗张强度密切相关。In this paper, the improvement of the property of unbleached kraft pulp by laccase treatment was studied. Fiber morphology, molecular weight and distribution of lignin of the pulp before and atter treatment were analyzed by scanning electron microscope （SEM） and gel permeation chromatography （GPC）. The mechanism of wet-strength improvement of the pulp by laccase treatment was discussed. At the same time, the effect of the addition of MS in laccase treatment, molecular weight and its distribution of lignin, morphology of fiber was also studied. The results showed that the molecular weight of lignin decreased and lignin adhered to the fiber surface when the pulp was treated with laccase alone. However, the wet-tensile indexes of handsheets were improved only when the handsheets were dried with heating to improve the polymerization degree and adhesion area of lignin. On the other hand in the laccase treatment with MS, the handsheets could have better wet-tensile indexes without heating drying due to the increase of polymerization degree of lignin and the adhesion area betweem lignin and fibers.

关 键 词：漆酶 丁香酸甲酯 硫酸盐木浆 木素分子质量 纸页表面形态 

分 类 号：TS743.14[轻工技术与工程—制浆造纸工程]