检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:王泽锋[1] 罗洪[1] 熊水东[1] 倪明[1] 胡永明[1]
机构地区:[1]国防科学技术大学光电科学与工程学院
出 处:《中国激光》2007年第1期105-108,共4页Chinese Journal of Lasers
摘 要:提出了一种用于干涉型光纤传感器动态相移测量的J0-J1法,实现了无源零差检测,而且信号解调算法简单,检测频带宽。详细介绍了该方法的基本检测原理,并对解调误差进行了理论分析与仿真,得出了系统能够检测的最大动态相移幅度与干涉仪的工作点允许变化的范围相互制约的结论。编写了实时的信号采集、处理程序,对某一干涉型光纤水听器探头的声压灵敏度进行了测量。在频带20-1300Hz上,平均声压灵敏度为-162dB(0dB=1rad/μPa),波动〈±1.0dB,单频点500Hz的灵敏度变化〈±0.5dB,与采用相位载波(PGC)调制解调法测量的结果基本一致,验证了J0-J1法的可行性。A J0-J1 method for measurement of dynamic phase changes in an interferometric optical fiber sensor is described. This method has the advantages of no electric elements in the sensing head and the simplicity of signal processing. The detection principle of this method is introduced in details. The demodulation error is analyzed and simulated theoretically. The measurable amplitude of the dynamic phase change and the permitted varying range of the work-point restrict each other. A system of data acquisition and processing is programmed, and an interferometric fiber-optic hydrophone is tested. The average acoustic pressure sensitivity is -162 dB (0 dB =1 rad/μPa) over the frequency range of 20 Hz to 1300 Hz, the fluctuation is smaller than ± 1.0 dB, and the change at 500 Hz is smaller than ±0. 5 dB, which accords well with the results obtained with the method of phase generated carrier (PGC) modulation and demodulation. The experimental results prove that this J0-J1 method is feasible.
关 键 词:测量 光纤传感器 信号检测 无源零差 工作点控制 相位载波调制解调
分 类 号:TB212.14[一般工业技术—工程设计测绘]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.38