HIP-SN陶瓷轴承套圈磨削特性的实验  

Experiment on Grinding Characteristic of HIP-SN Ceramic Bearing Rings

作　　者：吴玉厚[1] 吕艳[1] 

机构地区：[1]沈阳建筑大学交通与机械工程学院,辽宁沈阳110168

出　　处：《沈阳建筑大学学报（自然科学版）》2007年第1期142-146,共5页Journal of Shenyang Jianzhu University：Natural Science

基　　金：国家自然科学基金项目(50475167);沈阳市科技攻关项目(1041008-1-04)

摘　　要：目的研究HIP-SN陶瓷轴承套圈的磨削特性,提出改善氮化硅陶瓷套圈磨削效率和磨削质量的关键因素和条件.方法运用INV306DF振动采集仪在线监测HIP-SN陶瓷套圈在磨削加工中的振动信号,通过扫描电镜获得了磨削表面的SEM图.结果计算出Si3N4陶瓷临界磨削深度值dc为0.004 mm.由Coinv DASP2003进行频谱分析,得到不同转速下主轴单元振动幅频图.结论在实验条件下,提高砂轮速度有助于增加塑性变形,以获得较高的去除率;通过SEM图,得出陶瓷材料的去除机理包括塑性变形和延性切削;同时,适当地减小磨削深度、提高砂轮速度,将能够实现陶瓷的延性磨削、改善工件的加工质量.The anticle Introduced the excellent characteristic and researched significance of HIP - SN ceramic bearings and put forward the key factor of improving the grinding efficiency and quality of Si3N4 ceramic bearing rings. Theoretically it. discussed the physical and grinding characteristic of Si3N4 ceramic, calculated he critical grinding deep that needed. While grinding, we used the INV306DF vibration gathering apparatus to monitor the vibration signals, and analyzeit by Coinv DASP 2003. By grinding experiment, the vibration frequency diagram of grinding wheel axle was gained, along with the SEM chart of Si3N4 ceramic that grinded. By the analysis of SEM chart and vibration frequency diagram, we found relatively feasible grinding parameters. Sequentially, brought forward the key essence of improving the grinding efficiency and quality of Si3N4 ceramic bearing rings.

关 键 词：氮化硅陶瓷 磨削特性 塑性变形 磨削深度 

分 类 号：TU133.33[建筑科学—建筑理论] TB35[一般工业技术—材料科学与工程]