基于DSP的矿井电网选择性漏电保护的研究  

Selective Leakage Protection For Undergroud Distribution Networks Based On DSP

作　　者：刘子胥[1] 李国顺[1] 张长勇[1] 黄婷[1] 

机构地区：[1]河北工业大学电气与自动化学院,天津300130

出　　处：《煤矿安全》2008年第3期26-29,35,共5页Safety in Coal Mines

摘　　要：针对煤矿井下选择性漏电保护的问题,着重围绕零序功率方向性原理对该问题进行了研究,并结合DSP(Digital Signal Processor)技术给出了一种基于TMS320LF2407A芯片的零序电压、电流相位比较方案。这一方案是通过过零触发电路捕捉零序电压、电流的过零点,然后在软件上来比较零序电压、电流之间的相位关系,根据漏电故障支路与非故障支路中零序电压、电流之间相位的不同,从而实现漏电保护的选择性。同时为了验证过零触发电路的可行性,使用电子电路仿真软件Multisim9进行了触发电路的硬件仿真。最后根据选择性漏电保护的实现过程给出了软件设计流程图以及试验数据分析。In view of the problem with underground selective leakage protection, the paper focuses on the principle of zero -sequence power direction, and presents a scheme of phase comparison between zero sequence voltage and current based on DSP TMS320LF2407A, which can achieve the selectivity of leakage protection by zero - cross - over triggering circuit. This circuit is used to capture the zeros of zero sequence voltage and current, and then compare the phase relations between zero sequence voltage and current by the software. The selectivity of leakage protection can be achieved by the difference of phase between zero sequence voltage and current. At the same time,the electric simulation software named Multisim 9 is used to test the feasibility of the trigger circuit. According to the realization of selective leakage protection, the corresponding software design and test data analysis are put forward in this paper finally.

关 键 词：选择性漏电保护 零序功率方向性 过零触发电路 DSP 

分 类 号：TD611.5[矿业工程—矿山机电]