检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:安富强[1] 李平[1] 曲选辉[1] 郑雪萍[1]
机构地区:[1]北京科技大学材料科学与工程学院,北京100083
出 处:《北京科技大学学报》2008年第3期263-266,共4页Journal of University of Science and Technology Beijing
摘 要:提出用放电等离子烧结技术(SPS)改善La-Mg-Ni贮氢电极合金的综合电化学性能.所选La-Mg-Ni贮氢电极合金为La0.7Mg0.3Ni2.5Co0.5.实验结果表明,用SPS和真空中频感应熔炼制备得到的合金具有近似的最大放电容量.SPS技术增强了合金电极的循环寿命:在经过150次的充放电循环后,用SPS法制备的La0.7Mg0.3Ni2.5Co0.5合金的容量保持率为61.8%;而感应熔炼法得到的合金电极的容量保持率仅为39.6%.同时用SPS技术使合金的放电中值电压增加,放氢平台变宽,平台倾斜度减小.The electrode alloy La0.7Mg0.3Ni2.5Co0.5 prepared by the spark plasma sintering (SPS) technology was used to investigated the improvement in electrochemical properties of La-Mg-Ni hydrogen storage alloys, The experimental results indicated that the maximum discharge capacities of the electrode alloys respectively prepared by SPS and vacuum medium-frequency induction melting were close, Using the SPS technology would decrease the weakening rate of capacity of the electrode alloy, After 150 cycles, the retention rate of capacity was 61.8% for the SPS technology, but 39.6% for the induction melting method, At the same time, the SPS technology would also increase the discharge medium voltage, broaden the discharge platform, and decrease the gradient of the platform.
关 键 词:贮氢合金 电化学性能 放电等离子烧结(SPS) 真空感应熔炼
分 类 号:TG146.4[一般工业技术—材料科学与工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.117