3104铝板织构对r值及深冲性能的影响  

Influence of texture in 3104 Aluminum sheet on r values and deep drawing property

作　　者：马全仓[1] 徐阳 毛卫民[3] 

机构地区：[1]郑州大学材料学院,郑州450001 [2]洛阳有色金属职工大学,洛阳471039 [3]北京科技大学材料学院,北京100083

出　　处：《塑性工程学报》2008年第3期29-32,共4页Journal of Plasticity Engineering

基　　金：国家自然科学基金资助项目(50171014);科技部高科技发展规划“863”计划(2003AA331080)

摘　　要：以德国Hydro公司3104成品铝板为实验材料检测了铝板织构及板材塑性应变比r值。由板材织构基于Sachs模型和反应应力模型计算了铝板的工程r值及φ2=65°ODF截面的不同取向晶粒的r值。结果表明,立方织构及立方织构与S织构之间的过渡织构有较高的r0,而S织构的r45值较高,立方织构、S织构和它们之间的过渡织构都有较高的r90值,此3种织构组分造成3104板材r90值最高。增强过渡织构可同时提高r0和r90值。最佳的立方织构、S织构和过渡织构的体积配比,就有可能获得最小的深冲制耳,从而显著提高3104铝板的深冲性能及成材率。Texture and r values of 3104 Aluminum sheet of Hydro Corporation in Germany were measured. The r values of sheet were calculated by Sachs model and Reaction stresses model based on 3104 sheet texture and the r values of various orientations grains in φ2=65°ODF section were also calculated by means of Sachs model. Calculation results show that Cube and the transition-texture between S and Cube texture components have higher r0, and S has higher r45, S and Cube and transition-texture all have higher r90. These three texture components induce the highest r90 among r values of the sheet. The transition-texture can increase r0 and r90 simultaneously. Optimum volume proportion of S, Cube and transition-texture would minimize the earrings, thereby the deep drawing ability and output capacity of sheet could enhanced evidently.

关 键 词：铝板 织构 r值 深冲性能 塑性变形模型 

分 类 号：TG113.25[金属学及工艺—物理冶金] TG146.2[金属学及工艺—金属学]