检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李莉平[1] 姚正军[1] 阎凯[1] 张平则[1] 徐重[1]
机构地区:[1]南京航空航天大学材料科学与技术学院,江苏南京211100
出 处:《材料科学与工程学报》2008年第3期411-415,共5页Journal of Materials Science and Engineering
基 金:江苏省自然科学基金资助项目(BK2005128)
摘 要:本文利用双辉技术在20钢表面设计了六种不同顺序C、N、Ti三元共渗的工艺方案,以研究合金元素渗入顺序对渗层的影响。用金相显微镜、EDS、XRD、划痕仪、磨损仪分别对渗层的微观组织、成分、物相、结合力、耐磨性进行了表征。结果表明:不同的合金元素渗入顺序会对渗层的形成、组织、结构及性能产生很大的影响;采用方案1-3未能在基体表面形成渗层;采用方案4得到约7μm厚渗层,渗层内含有固溶相Ti2C0.06和Ti2N,渗层的表面硬度和耐磨损性能分别较基体提高了3倍和1倍多;采用方案5、6均能获得渗层厚度为40μm、含硬质相TiC、TiN的渗层,渗层与基体结合良好,其表面硬度超过2100HV,表面耐磨损性能较基体提高了8倍以上。In this paper, six processes about multi-element alloying sequence had been designed'to alloying with N, C and Ti on the surface of 20 carbon steel by double glow plasma surface alloying (DGPSA). The microstructure, composition, constituent phases, adhesion with substrate and wear resistance of the alloying layer were studied. The characterized results show no film had been produced in the first three plans. The results show that a 7btm alloying layer which was composed of Ti2C0.06 and Ti2N phases in No. 4 plan, Its surface hardness and wear resistance were 3 times and 1 time than substrate respectively. It has also been found that the films with 40btm had been produced in No. 5 and No. 6 plan. These films were composed of TiN and TiC phases and the adhesion with substrate exhibited well. The surface hardness of alloying layer was over 2100 HV and the wear resistance was 8 times than substrate.
分 类 号:TG174.445[金属学及工艺—金属表面处理] TG156.95[金属学及工艺—金属学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.191.97.68