检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:黄惠兰[1] 张华[1] 安恩科[2] 姚秀平[3] 邬志敏[1]
机构地区:[1]上海理工大学动力工程学院 [2]同济大学热能工程系,上海200092 [3]上海电力学院热能工程系,上海200093
出 处:《动力工程》2008年第4期647-650,共4页Power Engineering
基 金:国家自然科学基金资助项目(50476078);上海市重点科建设基金资助项目(T0503)
摘 要:分别以沙子、石子以及石子与充水黑色密封管的组合作为蓄热介质,搭建了太阳能集热器试验装置并进行了相应的试验研究,得出了不同蓄热介质的吸放热特性及其对集热器内空气进出口温差、集热器效率的影响规律.结果表明:在相同的平均辐射强度下,石子与充水黑色密封管组合集热器的蓄热性能好,且集热器空气进出口温差及集热器效率最大,为太阳能热风发电系统集热器地面蓄热材料的选用提供了依据.A test rig of solar heat collector was set up and corresponding tests were carried out taking sands, pebbles and combination of pebbles and water-filled black sealed tubes as thermal storage material (TSM), respectively. Heat absorption and release characteristics of different TSMs and their influence on temperature differences between air inlet and outlet of heat collector are obtained. Results indicate that the combination of pebbles and water-filled black sealed tubes shows a higher heat storage capacity under the same average radiation intensity. Temperature difference between air inlet and outlet of heat collector, as well as heat efficiency, of the combination of pebble and water-filled black sealed tubes are the highest among the three TSM heat collectors. Results provide a foundation for the selection of heat collector in solar chimney power generation system.
关 键 词:能源系统工程 太阳能热风发电 集热器 蓄热介质 热效率
分 类 号:TK514[动力工程及工程热物理—热能工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.129.73.179