检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:张明[1] 胡瑞林[1] 崔芳鹏[1] 谭儒蛟[1] 于进庆[1] 余文龙[1]
机构地区:[1]中国科学院地质与地球物理研究所工程地质力学重点实验室,北京100029
出 处:《岩石力学与工程学报》2008年第A02期3699-3704,共6页Chinese Journal of Rock Mechanics and Engineering
基 金:国家重点基础研究发展规划(973)项目(2002CB412702);"十一五"国家科技支撑计划项目(2006BAC04B02)
摘 要:以金沙江下咱日堆积体为例,阐述在考虑水岩物理化学作用的情况下,如何利用大型原位推剪试验求取堆积体天然状态下和与库水反应后的力学参数c,φ值,并利用所求得的参数建立随库水位上升时边坡稳定性计算的数值模型。通过计算得出:在只考虑水岩力学作用和考虑水岩力学、物理化学作用2种情况下,边坡的稳定系数随库水位上升的变化趋势是一致的,都是先减小,后升高,但是后者的稳定系数比前者有相当程度的降低,下降程度可以达到35.34%,甚至更多。所以,在实际的工程应用中只考虑水岩力学作用计算出来的稳定系数是不可靠的,误差非常大。Taking Xiazanri accumulation body for example, the parameters of accumulation body under natural situation and after physical and chemical reactions with reservoir water are obtained using large-scale horizontal push-shear in-situ test. Based on these parameters, numerical model to calculate the safety factor of reservoir accumulation slope is built. The results show that under two situations(with/without considering chemical and physical reactions between water and accumulation body), the changing trend of safety factor of slope is the same as the reservoir water level ascends, which decreases at first and then increases. However, compared with the former, the factor of safety under the latter situation decreases more, and decreasing ratio can reach 35.34% or more. Therefore, factor of safety calculated only considering the water-rock mechanical reaction is not reliable in practical engineering design.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.15