肋形隧道表面多孔管强化沸腾传热的研究  

INVESTIGATION IN ENHENCED BOILING HEAT TRANSFER ON POROUS SURFACE TUBES WITH RIBBED TUNNELS

作　　者：钟理[1] 谭盈科[1] 王世平[1] 

机构地区：[1]华南理工大学化学工程研究所

出　　处：《化学工程》1990年第4期26-32,共7页Chemical Engineering(China)

摘　　要：本文报道了肋形隧道机械加工表面多孔管(JK-2管)单管管外池沸腾实验。实验工质为R-113和R-11。实验结果表明:对R-113和R-11工质,JK-2管沸腾给热系数分别比光滑管高2.5～15倍及1～10倍,比JK-1管高20％～150％,而且,当工质为R-113时,JK-2管比光滑管的临界热负荷高约100％。并建立了一个池沸腾膜传热系数的准数关联式,其预测值和实验值的相对误差在±15％以内。The pool boiling experiments,in which the working fluids are R-113 and R-11, of a mechanically made porous surface tube with ribbed tunnels(i, e. JK-2 tube)are reported. The results show that the boiling film heat-transfer coefficients of JK-2 tube are 2.5-15 times and 1-10 times respectively for R-113 and R-11 working fluids more than those of smooth tubes,and 20％-150％ more than those of JK-1 tubes,and its critical heat flux for R-113 is about twice as much as a smooth tube. A dimentionless correlation of the above pool boiling film heat-transfer coefficient,which gives a relative error within ±15％ between the predicted and experimental values,is established.

关 键 词：沸腾传热 传热元件 表面多孔管 

分 类 号：TQ051.5[化学工程]