检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:孔泳[1] 王文昌[1] 韩佳妮[1] 朱冬冬 王金峰 陈智栋[1]
机构地区:[1]江苏工业学院化学工程系,常州213164 [2]江工阔智电子技术有限公司,常州213164
出 处:《分析试验室》2008年第11期48-50,共3页Chinese Journal of Analysis Laboratory
基 金:江苏省高校自然科学基金(06KJD150049)项目资助
摘 要:采用Na2CO3-NaHCO3为淋洗液和抑制电导检测,对酸性镀铜液中的微量氯离子进行检测。采用AgNO3作为沉淀剂使Cl-分离富集,再用Na2S2O3溶液溶解沉淀后进行检测,可以很好地消除酸性电镀液中高浓度SO4^2-的干扰。该方法线性良好,Cl^-的检出限为0.01μg/mL,回收率在98.6%-101.7%之间,由于该方法能够很好地消除大量SO4^2-的干扰,在电镀铜工业中对酸性镀铜液中氯离子的监控可发挥作用。Using Na2CO3 and NaHCO3 as eluents, trace Cl- in acidic copper-plating bath can be determined with anion-exchange and suppressor conductivity detection. A simple method which could eliminate the effect of SO4^2- by separation and enrichment of Cl^- in the copper-plating bath with AgNO3 as precipitant was discussed in this article. The recoveries of added standard were 98.62% - 101.70%, and good linearity and low detection limit for Cl^- were ohtained. The results indicate that the method is simple, rapid, accurate and sensitive for the determination of trace Cl^- in acidic copper-plating bath.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.112