检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]华中科技大学能源与动力工程学院,武汉430074
出 处:《内燃机工程》2008年第6期35-39,共5页Chinese Internal Combustion Engine Engineering
基 金:国家自然科学基金项目(50676036;20777023);国家重点基础研究发展规划(973)项目(2007CB210061)
摘 要:利用线形稳定性理论,推导出可用来描述粘性射流表面扰动发展所满足的色散方程,并进行了无量纲化处理,利用该色散方程对二甲醚射流在正常条件和闪急沸腾条件下的不稳定性进行了研究。结果表明,在正常喷射条件下,提高射流速度和减小液体粘度可促进二甲醚射流的雾化效果,而表面张力和环境气体密度对射流不稳定性的影响则相对复杂;在闪急沸腾喷射条件下,闪急沸腾效应越明显,二甲醚射流越不稳定。Based on the theory of linear stability analysis, a dispersion equation which describes the relation between disturbance growth rate and its wave number was derived, and the dimensionless form and solution procedure of the dispersion equation were obtained. In order to improve the understanding of atomization mechanism of dimethyl ether (DME) jet, the instability of DME jet under normal and superheated conditions were analyzed. Some valuable conclusions are obtained as follows: under normal condition, increasing the relative velocity and decreasing the liquid viscosity are able to improve the atomization of DME jet, while the influence of surface tension and surrounding air density on the DME jet instability are relatively complicated; the effect of flashing boiling is capable of improving the instability of DME jet under superheated condition.
关 键 词:内燃机 二甲醚 射流 雾化机理 不稳定性 闪急沸腾
分 类 号:TK464[动力工程及工程热物理—动力机械及工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.30