检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]山东省聊城市公路工程总公司第三工程处,聊城252000 [2]西南石油大学建筑工程学院,成都610500 [3]成都市交通委员会公路管理处,成都610041
出 处:《交通科技》2008年第6期57-59,共3页Transportation Science & Technology
摘 要:采用ASTM标准推荐的平板法,结合图像分析技术,定量测试了路用混凝土的水分蒸发速度、最大裂缝宽度、总开裂面积等早期塑性收缩指标。通过固定水泥用量、固定W/C条件下的2种试验方案研究了W/C和水泥用量对路用混凝土塑性收缩的影响;结果显示:水灰比以及水泥用量显著控制着混凝土塑性收缩的参数;裂缝最大宽度、总长度、裂缝总开裂面积随水灰比的增大而减小,而随水泥用量的增大而增大;路用水泥混凝土塑性收缩裂缝发生的早期水分蒸发速度为0.3~0.6kg/(m^2·h)。Using the slab method recommended by ASTM and the image analysis technology, the rate of water evaporation, total crack length and crack area are measured in this paper. Effects of the cement content and W/C on plastic shrinkage were studied by respectively fixing the quality of cement and W/C. Results showed that the parameters of plastic shrinkage are evidently affected by W/C and cement content. The max crack width, total crack length and total crack area are reduced with the increase of W/C, hut they are increased with the increase of cement content. Plastic shrinkage crack will occur when the rate of water evaporation is between 0.3-0.6 kg.·m^-2· h^-1.
关 键 词:道路工程 水泥混凝土 塑性收缩 水分蒸发速度 裂缝总长度 总裂缝面积
分 类 号:U416.216[交通运输工程—道路与铁道工程] TU755.7[建筑科学—建筑技术科学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28