基于推钢机机构的摇杆本体有限元分析  

Finite Element Analysis of the Rocker Based on Steel Pusher Mechanism

作　　者：任绪年[1] 乔翠侠[1] 包家汉[1] 

机构地区：[1]安徽工业大学机械工业学院,安徽马鞍山243002

出　　处：《机械工程师》2009年第1期94-95,共2页Mechanical Engineer

摘　　要：某中板厂板坯长度从1700mm增至2000mm,推钢机摇杆结构需作相应修改。采用ANSYS软件,建立了推钢机机构的整体模型,通过在各铰接处设置接触单元的方法,计算摇杆的强度。计算结果表明,摇杆强度满足使用要求。The structure of the steel pusher rocker should be amended according to the length of slab which increased from 1700mm to 2000mm in a medium plate Plant. The whole model of steel pusher was built up. The strength of the rocker was calculated in ANSYS by the way of setting up the contact element on Hinge Joint. The results show that the strength of rocker can satisfy the use requirement.

关 键 词：推钢机 摇杆 有限元分析 接触模型 

分 类 号：TH123.4[机械工程—机械设计及理论] Q242.21[生物学—细胞生物学]