凸轮轴楔横轧成形仿真与应力应变分析  

Numerical shaping simulation and stress-strain analysis of cam shaft cross wedge rolling

作　　者：胡福生[1] 王宝雨[1] 胡正寰[1] 

机构地区：[1]北京科技大学机械工程学院,北京100083

出　　处：《锻压技术》2009年第1期65-68,共4页Forging & Stamping Technology

基　　金：国家自然科学基金资助项目(50675019;50435010);北京市自然科学基金资助项目(3082013);国家科技支撑计划项目(2006BAF04B03)

摘　　要：提出了一种凸轮轴楔横轧成形新工艺,得出了楔横轧成形凸轮轴轧辊的辊形曲线和轧齐曲线。利用三维有限元软件DEFORM-3D对凸轮轴成形进行了数值模拟,在模拟轧制过程中,轧辊楔面排料的同时轧件上的凸轮轮廓也被轧辊上的凸轮凹槽逐渐轧制生成,并且逐渐被轧齐,得出轧件应力、应变场在凸轮顶端和芯部较小,在与轧辊楔面接触处最大,呈非对称分布的特点。模拟结果表明,用楔横轧工艺轧制凸轮轴是完全可行的。A new technology of cam shaft formed by cross wedge rolling was put forward. The roller profile and shaping curves of tools were obtained. The cross wedge rolling deformation process of the cam shaft was simulated with three-dimension finite element soft DEFORM-3D using rigid-plastic finite element method. During the process of simulating roll, the contour of the cam was gradually generated by cam groove while roller wedges were operating material discharge, and the inside right-angle step of rolling work piece was also gradually formed. The position of smaller stress-strain field was occurred at the apex and center of the cam. The maximum value was taken place at the areas between the work piece and the roller, and the total stress-strain field tended to symmetrical distribution. Simulation results indicate that the new technology of cam shaft formed by cross wedge rolling is feasible.

关 键 词：凸轮轴 楔横轧 有限元 

分 类 号：TG335.19[金属学及工艺—金属压力加工]