High performance differential CMOS LNA design for low-IF GPS receiver  

用于低中频GPS接收机的高性能CMOS差分低噪声放大器设计(英文)

作　　者：马伟[1,2] 江金光[2] 刘经南[2] 

机构地区：[1]武汉大学电子信息学院,武汉430079 [2]武汉大学GNSS中心,武汉430079

出　　处：《Journal of Southeast University(English Edition)》2009年第1期26-30,共5页东南大学学报（英文版）

基　　金：The National High Technology Research and Development Program of China(863Program)(No.2007AA12Z332)

摘　　要：A 1.575 GHz CMOS （complementary metal-oxidesemiconductor transistor） low noise amplifier（LNA） suitable for a low intermediate frequency（IF） global positioning system（GPS） receiver is presented. Considering parasitic effects resulting from bond pad and input electrostatic discharge （ESD） protection diodes, the optimization of the input matching and noise performance is analyzed, and a narrowband inductor model is applied to the circuit design and optimization. Based on the Volterra series, the nonlinearity of the LNA is analyzed and an equation describing input-referred third-order intercept points （IIP3） which indicate the nonlinearity effects is derived; accordingly, the trade-off between the power consumption and linearity is made. The LNA is designed and simulated with TSMC （Taiwan Semiconductor Manufacturing Company） 0. 18 μm radio frequency （RF）technology. Simulation results show that the LNA has a noise figure of only 1.1 dB, - 8. 3 dBm IIP3 with 3 mA current consumption from a 1.8 V voltage supply, and the input impedances match well.设计了一个可用于低中频GPS接收机系统的1.575GHz的低噪声放大器.首先考虑了ESD保护二极管和焊盘的寄生效应,对输入匹配和噪声性能的优化做了分析,并将窄带电感模型用于电路设计优化.其次基于Vol-terra级数,对放大器的非线性做了分析,推导了电路各参数与IIP3的关系表达式,据此在功耗和线性度之间做了折衷考虑.采用TSMC0.18μm射频工艺对低噪声放大器进行设计和仿真.仿真结果表明:在1.8V工作电压下,噪声系数仅为1.1dB,IIP3为-8.3dBm,电流消耗3mA,电路的输入匹配良好.

关 键 词：low noise amplifier （LNA） NONLINEARITY electrostatic discharge （ESD）protection diode 

分 类 号：TN722.3[电子电信—电路与系统] TN722