检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]国防科学技术大学光电科学与工程学院,长沙410073
出 处:《强激光与粒子束》2009年第4期633-636,共4页High Power Laser and Particle Beams
基 金:国家高技术发展计划项目
摘 要:分析了四级传输线脉冲变压器的电路结构,采用等效电路方法简化了电路,推导了输出电压波形的表达式。开展了冷测实验,结果显示传输变压器变压比约为4,变压器上升时间约为48 ns。采用实验所测参数,利用PSPICE软件对全电路进行了数值模拟。结果表明:模拟和冷测结果基本一致。将各元件参数代入波形表达式,结果表明:传输变压器上升时间计算值为12 ns,与实验值(48 ns)有一定差距;而传输变压器变压比计算值为3.98,与实验结果基本吻合。The circuit diagram of a 4-stage voltage transmission line transformer(TLT) is analyzed. The circuit is simplified by means of equivalent circuit, and the expression of the output waveform is derived. The low voltage test of the 4-stage TLT is developed, the result of which indicates the voltage ratio is about 4 and rise time 48 ns. The result of simulation with PSPICE is in good agreement with the test. With the same parameters, theoretical calculation of output voltage amplitude is 3.98 which corresponded to measured value 4. However, there is some discrepancy between calculated value of TLT's rise time (12 ns) and measured value (48 ns).
关 键 词:传输线脉冲变压器 等效电路 冷测实验 PSPICE模拟
分 类 号:TL503[核科学技术—核技术及应用]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.147