嵌入式WinCE网络驱动的开发及实现  

Development and implementation of network driver based on embedded WinCE

作　　者：周少平[1] 师奕兵[1] 付在明[1] 

机构地区：[1]电子科技大学自动化工程学院,成都610054

出　　处：《电子测量技术》2009年第7期50-52,88,共4页Electronic Measurement Technology

摘　　要：嵌入式WinCE系统由于某些源代码没有公开,该系统下网络驱动的开发相对比较困难。本文根据WinCE网络驱动程序结构,以基于WinCE5.0内核在脉冲发生器嵌入式主板上移植CS8900网卡驱动程序为实例,详细分析了WinCE嵌入式系统下网络设备驱动程序的开发流程,重点讲述了网络设备驱动与WinCE操作系统内核之间的通信方法以及驱动程序的编译与加载,最后通过实验验证了该驱动程序的可行性。For some codes of Embedded WinCE are not open, it is difficult to develop network driver. In this paper the structure of network driver based on WinCE had been analyzed. Combined with the transplant of CS8900 network interface driver using WinCE 5. 0 kernel based on Pulse Generator＇s experiment board, the development process of network driver in embedded WinCE was emphatically discussed, besides the detailed analysis of communication method between driver and the system kernel and how to make and load driver were given. At last the possibility of the driver was validated through experiments.

关 键 词：嵌入式WINCE CS8900 以太网控制器 NDIS 驱动 

分 类 号：TP393.06[自动化与计算机技术—计算机应用技术]