直流输电系统PLC噪声滤波器的设计  

Design of PLC Noise Filter in HVDC Systems

作　　者：张琪祁[1] 郝全睿[1] 黄莹 黎小林 徐政[1] 

机构地区：[1]浙江大学电气工程学院,杭州310027 [2]南方电网技术研究中心,广州510623

出　　处：《高电压技术》2009年第9期2299-2305,共7页High Voltage Engineering

基　　金：国家"十一五"科技支撑计划重大项目(2006BAA02A21)~~

摘　　要：为了抑制直流输电系统中因换流阀导通和关断时电压突变在交直流线路上产生的大量电力线载波(PLC)噪声,并将其降到规定的限制标准,减少对PLC通信系统产生干扰,在PLC噪声滤波器设计中应用了电磁兼容(EMI)滤波器的设计原理。通过与EMI滤波器进行对比,得出PLC噪声滤波器的特点并根据噪声源和负载不同的阻抗特性,给出了4种适用的PLC噪声滤波器的网络拓扑,并详细说明了各种结构中主参数和调谐参数的确定方法。最后用Matlab/Simulink作为仿真平台,以贵广二回直流输电系统深圳换流站交流侧PLC噪声滤波器设计为例,证明所提出的设计方法是可行的。Power-line carrier （PLC） interference noise is caused by the voltage breakdown in converter valves during the firing processes. The noise propagates along DC and AC lines, interfering with the PLC communication system. In order to suppress the noise to meet the limit requirement, PLC filters are installed. From the perspective of fre- quency domain, the principle of PLC noise filter is similar to the EMI filter. We applied the EMI filter design princi- ple to the PLC noise filter, summarized the characteristics of the PLC noise filter and compared with the EMI filter, and put forward the design process of the PLC noise filter. Moreover, according to the different impedance charac- teristics of the noise source and the load, four different kinds of network topology were proposed to design the PLC noise filter, also the way to determine the main parameters and tuning parameters of the PLC noise filter was expati- ated. Finally the method was applied to the design of the PLC noise filter in AC side of Shenzhen converter station in Guizhou-GuangdongⅡ HVDC transmission project, and the result verifies the validity of the design method.

关 键 词：直流输电系统 电力线载波 电磁兼容 滤波器 设计 仿真 

分 类 号：TN713[电子电信—电路与系统]