检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:张华中[1] 王维庆[1] 朱玲玲[1] 孔令凯 周培毅[1] 梁思聪[1]
机构地区:[1]新疆大学电气工程学院 [2]许继电气股份有限公司,河南省许昌市461000
出 处:《电网技术》2009年第18期209-213,共5页Power System Technology
基 金:国家自然科学基金项目(50867004);自治区高技术研究发展计划项目(200614118)~~
摘 要:平行双回线结构的特殊性以及零序互感等因素造成距离保护继电器耐受过渡电阻的能力较弱,严重影响继电器的性能,传统的距离保护方法难以满足高压平行双回线的要求。该文针对双回输电线路的单回线路单相接地故障,提出双回输电线路的自适应距离保护方法,该方法借助正、负、零序电流的权重系数和传统距离保护的测量阻抗,计算出保护的附加测量阻抗,对传统距离保护的计算结果进行修正,并给出正、负分支系数相角的估算方法。仿真结果证明这种自适应距离保护方法能有效防止保护的超越和拒动。The structural particularity and zero-sequence mutual inductance of parallel double-circuit transmission line make the ability of distance protection to withstand transition resistance weaker, and it is difficult for traditional distance protection to meet the demand of high-voltage parallel double-circuit transmission line, so the performance of distance protection is seriously affected. In this paper, for the single-phase earth fault occurred in one circuit of the double-circuit transmission line an adaptive distance protection approach for parallel double-circuit transmission line is proposed. By means of weight coefficients of positive-, negative- and zero-sequence currents and the measured impedance in traditional distance protection, the additional measured impedance of the protection is calculated to modify the calculation results of traditional distance protection; and the method to estimate phase angles for positive- and negative-sequence branch coefficients is given. Simulation results show that the proposed adaptive distance protection can effectively prevent overreach and no-response of distance protection.
关 键 词:自适应距离保护 双回输电线路 权重系数 过渡电阻
分 类 号:TM771[电气工程—电力系统及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.166