载荷对4种材料摩擦机制转变的影响  

Load Effect on the Translation of Friction Mechanism of Four Materials

作　　者：谢祖飞[1] 余家欣 钱林茂[1] 

机构地区：[1]西南交通大学牵引动力国家重点实验室摩擦学研究所,四川成都610031

出　　处：《上海交通大学学报》2009年第12期1930-1935,共6页Journal of Shanghai Jiaotong University

基　　金：国家自然科学基金资助项目(90923017,50625515,50821063)

摘　　要：采用曲率半径2μm的金刚石针尖,分别在原子力显微镜和纳米划痕仪上研究了GCr15、304不锈钢、超弹和形状记忆NiTi合金等材料在5μN^80 mN载荷的摩擦学性能.结果表明,载荷对材料的摩擦机制有很大影响.当载荷低于80μN时,4种样品表面均无明显的划痕损伤,摩擦机制以界面摩擦为主;100~150μN时,摩擦机制逐渐转变到以犁沟摩擦为主;80 mN时,4种材料犁沟摩擦力占总摩擦力的比例甚至超过90%.另外,材料的硬度和弹性模量对其摩擦性能也有显著影响.硬度越高,材料越难发生犁沟损伤,摩擦机制从界面摩擦转变到犁沟摩擦对应的载荷越高;弹性模量与硬度的比值越大,摩擦过程中的犁沟效应越显著,犁沟摩擦力占总摩擦力的比重越大.By using a diamond tip of 2μm in curvature radius, the tribological properties of GCr15, 304 stainless, superelastic and shape memory effect NiTi alloys were investigated under 5 μN～80 mN with an atomic force microscopy and nano-scratch tester, respectively. The results indicate that the load exhibits a strong effect on the friction mechanism of materials. When the load is below 80 μN, no obvious damage is observed on four samples and the interracial friction should be dominated. While the load increases to 100 ～150 μN, the plough friction becomes dominated. As the load attains 80 mN, more than 90% of the friction force is induced by plough. Also, the hardness and elastic modulus of materials reveal a significant effect on their friction behaviors. The higher the hardness of material, the more difficult to be ploughed the material, and the larger the translation load between interracial friction and plough friction. In addition, when the material has higher ratio of elastic modulus to hardness, the plough should be more dominant during the scratch process.

关 键 词：摩擦机制 界面摩擦 犁沟摩擦 原子力显微镜 纳米划痕仪 

分 类 号：TH117[机械工程—机械设计及理论]